Besides 2 less fans maxing out, it makes it clear if the radiator fans do max there is an issue. However, the XT can read its own sensor at all times. The C-Pro needs cue running to fetch the water temp data so your fans are going to run at high speed when cue is not operational (boot, shutdown, bios). If you completely quit iCUE and the rvice and CPUID service in the task manager. These do not affect functionality unless you direct a fan in CUE to use one of the false values as a sensor. You may wish to keep the two radiator fans on the AIO fan controller for speed control vs the Commander. Nothing on your motherboard is 127C or below room temp at 15C and the crazy cpu fan header registers 65,000 rpm even when nothing is connected. All the fast temperature changes the CPU experiences are absorbed. The fan speed should be controlled by the water temperature (H100i temp) and not CPU temp. As for iCUEs CPU temp sensors i dont know, but you dont need it either for the AIO. However, it would be very unusual for it to happen to all fans. in BIOS you can only control the motherboard fan headers, so thats normal. Sometimes you get funny contact on a pin and this is all it takes. Things like RAM or pure lighting controllers are OK. The AIO, Commander Core controller, and the PSU are the ones to disable. You can use HWinfo with CUE, as long as you disable HWinfo's monitoring of specific CUE internal devices. Nothing on your board is going be to be 100C plus at idle. A 0.0C temp there or other bad data would indicate a sensor level problem vs software. Wait 30 seconds and PSU back on and start normally.įinal try, with the pc running and CUE operational, disconnect and reconnect the PWM connectors to the Commander Pro one by one. If the room temp is 21C and you have motherboard components reporting 10-16C, you know these are false. HP Pavilion 14 Inch 1024x76860Hz 4:3 Aspect Ratio CRT Monitor: Case: None: Audio Device(s) Various: Power Supply. Corsair Crystal 280x - front glass and top filter removed. Wondering if you think these temps are okay or too high, and what I. If it did not work, do a full shutdown and flip the PSU off. Recently upgraded my GPU and have started paying proper attention to my temps. If not, you want it on 4 pin anyway so it doesn’t needlessly power test the fans at start up. Two included repositionable temperature sensors allow you to accurately monitor temperatures throughout your system with CORSAIR iCUE software. ![]() ![]() ![]() Change the pin selector from “auto” to 4 pin (PWM). Go into CUE settings for the Commander Pro.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |